Side entry ignition Coil – original Rewound – cost £725 GBP
there is a £450 surcharge on top of this item which will be refunded on receipt of a service exchange unit- please read note below.
We are able to offer service exchange units – please note- an exchange unit must be received in a re-windable condition – this means no cracks or splits in outer casing, both thread inserts in casing present and not pulled / stretched out of bakelite. it must be complete with cap and retaining knob. It is also your responsibility to ensure the core unit is wrapped and shipped securely. Â please note we are unable to accept potted or aftermarket coils as exchanges as these are not serviceable units. if you are unsure please contact us prior to purchaching.

Square headed bolt, 5/16 Bsf x .8750. New old stock (Loc F93)
Rolls Royce Phantom III kingpin Tri corner top housing
Rolls Royce phantom III Water pump O ring seal to Cylinder block (loc M72)
Rolls Royce Phantom III Oil pressure relief valve Gasket (Loc G62)
Square headed bolt, 5/16 Bsf x 0.710, new old stock. (Loc H15)
Rolls Royce Phantom III carburettor choke clockwork type spring (Loc G52)
Bulkhead carpet fastener post (loc F69)
Rolls Royce Phantom III 3 water pump body trunk housing
Rolls Royce Phantom III 3 steering box cam rocking shaft bearing Bolt (Loc H73)
Rolls Roye Phantom III 3 Clutch operating finger
Rolls Royce Phantom III Cylinder Liner sealing rings set of 24
Rolls Royce Phantom III Kingpin Thrust Pad
Rolls Royce Phantom III lower fulcrum pin Bolt 0.875 Large diameter
Rolls Royce Phantom III Front suspension Lower Bumpstop (loc M56)
Rolls Royce Phantom III Rear shock absorber link double ball assembly
Gasket, Bentley water jacket, water pump plate to block, 6 hole (loc E41)
Felt strainer One shot resivoir tank (loc F97)
Rolls Royce Phantom III sump strainer sealing washer (loc A122)
Derby Bentley 3.5 & 4.25L jet lever return spring (loc C21)
Gasket 20Hp & 20/25 rear end plate cover cylinder head (loc B22) 

