Side entry ignition Coil – original Rewound – cost £725 GBP
there is a £450 surcharge on top of this item which will be refunded on receipt of a service exchange unit- please read note below.
We are able to offer service exchange units – please note- an exchange unit must be received in a re-windable condition – this means no cracks or splits in outer casing, both thread inserts in casing present and not pulled / stretched out of bakelite. it must be complete with cap and retaining knob. It is also your responsibility to ensure the core unit is wrapped and shipped securely. please note we are unable to accept potted or aftermarket coils as exchanges as these are not serviceable units. if you are unsure please contact us prior to purchaching.

Rolls Royce Phantom III Inlet / water rail to Cylinder head Long gasket. (loc K01)
Rolls Royce Phantom III 3 water uptake necks to radiator RH
Rolls Royce Phantom III sump strainer sealing washer (loc A122)
Rolls Royce phantom III Carburettor Accelerator pump / plunger (Loc G32)
Lock Tab washer 1/4 RH tab (loc F74)
Rolls-Royce Phantom III gearbox gear change bracket gasket. G81977 (Loc B11)
Spark plug Phantom III (loc D41)
Water pump flexible drive rubber disc coupling, Small Hp, Phantom II and late 20/25. E53983 (loc G37)
Rolls Royce phantom III Water pump O ring seal to Cylinder block (loc M72)
Shim 1.440 OD x 1.188 ID Cam bearing shim (LocJ71)
Starter motor plant gear reduction gear drive bearing 4.25L (loc H22)
Rolls Royce Phantom III lower fulcrum pin Bolt 0.875 Large diameter
Dynamo Rubber drive coupling 3.5litre, Phantom I and Phantom II magneto and dynamo drives E74889. (loc G37)
Wiper blade flat, peg type 8” (LocK88)
Bulkhead carpet fastener post (loc F69) 

