Side entry ignition Coil – original Rewound – cost £725 GBP
there is a £450 surcharge on top of this item which will be refunded on receipt of a service exchange unit- please read note below.
We are able to offer service exchange units – please note- an exchange unit must be received in a re-windable condition – this means no cracks or splits in outer casing, both thread inserts in casing present and not pulled / stretched out of bakelite. it must be complete with cap and retaining knob. It is also your responsibility to ensure the core unit is wrapped and shipped securely. please note we are unable to accept potted or aftermarket coils as exchanges as these are not serviceable units. if you are unsure please contact us prior to purchaching.

Rolls Royce Phantom III P3 Crankcase heat exchanger plate gasket (LocE54)
Square headed bolt, 3/8 Bsf x 1.100. new old stock (Loc H41)
Water pump drive bearing, Bentley, 25/30 and 20HP (LocH23)
Derby Bentley rear wheel bearing outer (LocH21)
Phantom III distributor cross shaft core plug cap (Loc G73)
lock tab washer, Main bearing oil feed banjo, 20Hp & 20/25 to GXB26. E19192 (LocF122)
Rolls Royce, Bentley, Lagonda pre war car dashboard pull switch (loc M47-M48)
Rolls Royce Phantom III steering box rocking shaft oil seal (Loc G65)
1/4 bsf brass half nut (LOC K14)
Lock tab washer, vibration damper / slipper drive central nut (loc F115)
Rolls Royce Phantom III 3 ABC series Inlet valve (LocJ76)
Nut, temperature sender union 4 1/4l , 25/30, PIII- NOS - D75632 (Loc G73)
Rolls Royce phantom III Flywheel Starter Ring Gear and Starter pinion Gear
Rolls Royce Phantom III 3 steering box cam rocking shaft bearing
Rolls Royce phantom III NEW Carburettor Float Chamber Body - Aluminium (loc E47/ E48)
Gasket, waterpump to Elbow 20HP & 20/25 Rolls Royce (loc E41) 

